ssi_logo

9323 Hamilton

Mentor, Ohio 44060 - USA

Tel:+1-440-357-1400

Fax:+1-440-357-1416

Scientific Solutions ® Inc.,

LabMaster ® DPCI Ribbon Cable Connections

LabMaster DPCI Ribbon Cable Product
LabMaster DPCI PC Interface Card shown with Ribbon Cable DeskTop unit


LabMaster DPCI Ribbon Cable Connections
Back of the DeskTop unit showing the standard Ribbon Cable Connections

Description of the LabMaster DPCI Ribbon Cable Product
The LabMaster DPCI product consists of two cards;
(1). The LabMaster DPCI PC Interface which is installed inside the computer
(2). LabMaster DPCI External card which is housed in a DeskTop unit away from any internal computer noise. 

In this configuration, the DeskTop unit contains Ribbon Cable Header connections that are the same size and pin out of the LabMaster DMA / ISA product.  This allows current ISA customers to utilize their existing ribbon cables and literally unplug them from their ISA product and connect them to the DeskTop unit..

The DeskTop unit has the following Ribbon Cable Header connections on the back:


The Back of the DeskTop unit has also has connections for the LabMaster DPCI PC Interface and for the power supply.  The LabMaster connection is a DB25 pin connector.  The power supply uses a 2.1mm positive center post connection.  The LabMaster DPCI requires a 5v power supply that is also provided with the unit.

All of the data acquisition cirucits A/D, D/A, Digital I/O , Counter/Timer are external to the computer and are controlled by the LabMaster DPCI card in the computer using a single quick-connect round cable.  The LabMaster DPCI is 100% register level compatible to the original PC LabMaster product introduced in 1981.

LabMaster DPCI DeskTop Unit:
The DeskTop unit is about 11" wide x 7" deep x 4" high (280mm x 180mm x 100 mm).
Two lights on the front of the DeskTop Unit illuminate to indicate the presence of power.  One light indicates the power supply is connected and turned on, and the other light indicates the computer is connected and turned on.

DPCI RC DeskTop Front View
Front View of DeskTop unit


Inside the DeskTop unit are the various electrical circuits along with some switch and jumper positions that are used to customized the unit for particular software.  To access the inside, clips in the four corners of the top are "popped off" with a small flat-bladed screw driver.  Under each clip is a philips screw that is also removed.  Be sure to save and not loose the screws as they are metric thread and difficult to replace.



remove top 1    remove top 2

remove top 3    remove top 4 


The LabMaster DPCI Card:
The LabMaster DPCI card is a small card that installs into a 32-bit PCI slot.  It is approximately 2" x 4" (50mm x 100mm).  The card has a single DB25 socket connector.


LabMaster DPCI Card
LabMaster DPCI PC Interface shown.

Connecting the LabMaster DPCI and the DeskTop Unit:

To connect the LabMaster DPCI and the DeskTop Unit, use the following steps:

DeskTop Power Supply

Lab Master DPCI to DeskTop Cable
DeskTop Unit Power Supply
 (Included with product)
LabMaster DPCI to DeskTop Cable
 (Included with Product)